Here you can find information regarding repairs to the Chevy Equinox rear end system. These repairs include the
rear control arms installation, the rear swaybar information and bolt torque specs,
the rear diff fluid change procedures, and the rear end watts system installation. All of these repairs and
procedures include in depth details on how to perform the replacement and or repair. They
also contain all the detailed torque specs needed for each bolt involved in the repair.
Rear Wheel Hub Torque Specs
The Equinox rear wheel hub is held to the vehicle much like the front wheel hubs. There are 4 bolts which torque into nuts that
hold the hub onto the rear wheel suspension. To remove these bolts and the hub assembly you will first need to jack up the vehicle and
remove the braking system from the corresponding side of the vehicle. Once out of the way you can remove the bolts by using the access
holes on the hub plate itself. Be sure to hold the nuts on the other end with a wrench. Once all 4 have been removed you can then remove
the rear hub assembly and place a new part into its place. The 4 bolts can be torqued down to 44 ft-lbs.
To replace the rear shocks on a Chevy Equinox you will need to remove two sets of bolts/nuts located at the bottom
and top of the shock. Both of these fasteners can be accessed from underneath the vehicle by jacking it up and removing the
wheel. There is a single nut that will need to be removed from the inside of the trunk.
To uninstall the old shock simply just remove both of the fasteners sets and the part will come out. When installing the new
part reverse the procedure and tighten up the lower bolt to 55 ft-lbs and then the upper bolts and single nut to 25 ft-lbs.